Copter

New project in my hands. I got pretty much all parts, now is time to find what parts I missed, assembly and test. Lots of photos down there.

Here is power controller in original package.
Power controller in original package

Power controller not attached yet.
Power controller, not attached

Original motor wires.
Motor wires

Power controller assembly.
Power controller

Motor in original box.
Motor inside

Here is motor itself.
Motor

Turbine, side view.
Motor parts, side view

Turbine assembly.
Turbine assembly, front view

Turbine assembly, top view

Frame, still attached to piece of plywood. It was covered by sticker paper. You can see some pieces of it.
Frame, front view

Frame, front view, close look

Same sheet of plywood, view from back. You can see same sticky paper there. Very neat actually.
Frame, back view

Parts of copter’s frame are detached now.
Parts detached

Lower plane

Frame is assembled now (not permanently), turbine is sitting on its place, blue battery on right side.
Preliminary assembly with one motor

Same frame, controller, power controllers, receiver and other motors with connected wiring on top.
Preliminary assembly with motors, controller and receiver

Frame from top view.
Preliminary assembly, top view

That’s all so far.

One thought on “Copter”

Leave a Reply

Your email address will not be published. Required fields are marked *